Sixty-Four Point Certification Checklist
Cosmetics:
New Cover
Custom made cover
Redwood
Sanded
Treated
Painted or stained
Frame
Bottom reinforced if needed
Any Dry Rot Board replaced
ABS plastic if needed
Cabinet
Inside of cabinet cleaned
Sealed
Stained or painted
Trim
Painted or stained
Controls
Cleaned
Sealed and re-caulked
Brass/Steel Fittings
Cleaned or replaced
Filter
New Filter
Cover cleaned
Weir cleaned
Mechanical:
Timer
Turns equipment on and off
Keeps time
Jets
Proper Power
Rotating jets spin freely
Correct Air/water combination
Diverter Valves work properly
Air Venturies adjust airflow
Blower
Proper Power
No air inlets blocked
Heating system
Heater elements pulls proper amps
Heats to 104
Thermostat calibrated
Hi-limit shuts off spa
Flow switch
Topside
Air buttons
Toggle sequence
Digital Display
Caulked and sealed
Spa Pack
Air switches
Fuses
Switches/Relays
Contactors
Proper Gauge wire
Ground
GFCI
Shuts off spa
Proper load
Ground
Light
Toggles on/off
Good bulb
Cover
Plumbing
All plumbing tightened
No leaks
Slide valves open/close
Check valves H20
Check valves air
Drain valve
Interlock
Magnets aligned
Cuts power to spa
Ozone
Bulb or CD functioning
Line to tub cleared

Pump

Low/High speed
Seals
Bearings
Correct amps
Ground
Wet Ends
Suction/Return tightened
Impeller
 
~
~
~
Visit our showroom at: 1309 N Santa Fe Vista, CA 92084 | Phone: (760) 945-5718
©2004 Pacific Coast Spas. All rights reserved.